VXDIAG Multi Tool Connection via USB, LAN and WiFi

This is VXDIAG multi tool connection guide.

VXDIAG Hardware Connection have three connection mode :
USB Connection
LAN Connection
WiFi Connection

VXDIAG USB/LAN Connection
Connect OBDII cable to the vehicle 16pin diagnostic port, and USB/LAN cable to the computer.

VXDIAG-Multi-Tool-Connection-Guide-1

After device boot complete, the power led will flash, and the buzzer will prompt.
Install USB driver for Windows 7/8/8.1/10
The first time to connect USB cable to the computer, Windows will prompt [Installing device driver] . Windows automatically complete driver installation.

VXDIAG-Multi-Tool-Connection-Guide-2

Install USB Driver for Windows xp
The first time to connect USB cable to the computer, Windows will prompt [Found New Hardware]

VXDIAG-Multi-Tool-Connection-Guide-3

Please follow these steps to complete USB driver installation.
1. Select [No, not this time], then click [Next]

VXDIAG-Multi-Tool-Connection-Guide-4

2. Select [Install Driver Automatically], then click [Next]

VXDIAG-Multi-Tool-Connection-Guide-5

3. Please wait while the wizard installs the software

VXDIAG-Multi-Tool-Connection-Guide-6

4. Complete Found New Hardware Wizard, click [Finish]

VXDIAG-Multi-Tool-Connection-Guide-7

5. Thereafter, it will pop up the second time [Found New Hardware Wizard], same as above.
6. The USB Driver installed completed

VXDIAG-Multi-Tool-Connection-Guide-8

After USB driver is successfully installed, PC LED will flashing.
7. Start VX Manager program,select [Device],then click [Configure], Connection Type select [Auto],click [Save],Restart VX Manager program?

VXDIAG-Multi-Tool-Connection-Guide-9

Please make sure the device is connected.
Run VX Manager, The information of device will be displayed in “Device Manager”.

VXDIAG-Multi-Tool-Connection-Guide-10

VXDIAG WiFi Connection
Connect OBDII cable to the vehicle 16pin diagnostic port, and computer connect to the device through WiFi.

VXDIAG-Multi-Tool-Connection-Guide-11

1.Click VCX-WiFi, and check [Connect automatically] ,then click [Connect]

VXDIAG-Multi-Tool-Connection-Guide-12

2.Setting obtain an IP address automatically

VXDIAG-Multi-Tool-Connection-Guide-13

VXDIAG-Multi-Tool-Connection-Guide-14

3.Start VX Manager program,select [Device],then click [Configure], Connection Type select [WLAN],click [Save]

VXDIAG-Multi-Tool-Connection-Guide-15

VXDIAG-Multi-Tool-Connection-Guide-16

VXDIAG-Multi-Tool-Connection-Guide-17

4.Restart VX Manager program,computer have been connected to the device through WiFi

VXDIAG-Multi-Tool-Connection-Guide-18

completed

Add Comment

Required fields are marked *. Your email address will not be published.