CGDI Prog BMW Program X6 BDC Smart Key Success

CGDI Prog BMW MSV80 Key Programmer new test: successfully did/program BMW BDC key to the new model X6.

Attach photos here: (Technicians use the software in Chinese; have translated into English. Wish you have fun here)

12-1 12-2 12-3 12-4 12-5 12-6 12-7 12-8

12-8

How to use CGDI Prog to program BMW X6 BDC key? The main steps:

Check all connection

Run Automotive Key Programmer CGDI PROG BMW software

Go to FEM/BDC key match

update the ECU program

remove the FEM BDC

read and save data from EEPROM chip on FEM BDC computer board

read the original car EEPROM data file

reading the chip data

save data

write the calculated new data to the EEPROM chip

then put the FEM BDC back into the car

Write EEPROM

Check the BDC connection

write the calculated new data to the EEPROM chip

then put the FEM BDC back into the car

The ECU is being programmed…

Again, write EEPROM

Again, write EEPROM

remove the FEM BDC

then use the CGDI BMW Programmer to write the original car EEPROM data back to  EEPROM chip and FEM BDC back into the car

Coding is successful!!!!

Job’s done.

Add Comment

Required fields are marked *. Your email address will not be published.